« previous next »
Pages: 1   Go Down

Author Topic: want to buy : parts needed to convert progressive tool to 9mm  (Read 10951 times)

0 Members and 1 Guest are viewing this topic.

DSC

  • Posts: 2
    • View Profile
want to buy : parts needed to convert progressive tool to 9mm
« on: March 04, 2014, 12:28:43 pm »
please call me at 760 920 2963 if you can help me with the parts needed to convert me progressive tool to 9mm with adjustable powder slide.
thanks,
Scott Clark
Logged

NYKenn

  • Active Members
  • ***
  • Posts: 506
  • Distinguished Pistol Shot
    • View Profile
    • The Firing Line
Re: want to buy : parts needed to convert progressive tool to 9mm
« Reply #1 on: March 04, 2014, 09:13:58 pm »

Two members on this site make quality components for this caiber.

Dave Wilson (FC60) on this site makes dies.

Rich Daniels (Barreltester) on this site makes shellplates and adjustable powder bars.
I have one of the bars that works and is of excellant quality.

Most of the other parts are required for small primers are somewhat more readily available. For tubes and some primer parts, send a note to Bruce WIlliams (RBWillNJ) on this site.
Logged
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms shall not be infringed"

WWW.TheFiringLineNY.com

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1226
    • View Profile
    • Star Machine Works
Re: want to buy : parts needed to convert progressive tool to 9mm
« Reply #2 on: March 04, 2014, 10:43:15 pm »
If your reloader is truly a Progressive, you might run into a problem with converting it to 9MM.   The diameter of a standard 9MM shell plate is about 0.010" too big to fit a Progressive.   Either the shell plate or the reloader would have to be modified.   There are other potential issues too.
Logged
Star Machine Works
Star, the original blue Press.  Made by machinist, not machines.
www.StarMachineWorks.com
Pages: 1   Go Up
« previous next »