Safety taper die station

[Big Earl]

I have just set up for stuffing 45acp and on the tool head is a safety taper die.   My question is after the loaded and bullet seated round is moved to this station ( under the taper die ) the base of the cartridge in on top of the drop hole.
Am I missing something here?   What supports the cartridge when the tool head is lowered?  It also appears that he safety cam should be removed so the round can be extracted.   The outer edge on the cam makes cartridge removal difficult.    Knowledge greater than mine would be most appreciated.   Thanks!

Big Earl

[varmintpopper]

Big Earl
When useing a taper crimp die You must have a solid plug that fills the hole in the last station. You may want to go
to the "for sale" section on this forum and and inquire if anyone has one for sale. they can also be manufactured by a
machinist. and we are very fortunate to have some top notch machinist as members.

Good Shooting

Lindy

[Big Earl]

Just sent request to rbwillinj who said he had one.

Thanks.