Author Topic: Recomended Primer?  (Read 7206 times)

0 Members and 1 Guest are viewing this topic.

prc104

  • Posts: 2
    • View Profile
Recomended Primer?
« on: June 23, 2008, 10:40:05 am »
Hi All,

My first post on the site!

Anyone have any recommendations on what is the best primer manufacturer/type to use with the star progressive?

Or for that matter, which ones feed poorly?

Thanks,

-steve

NYKenn

  • Active Members
  • ***
  • Posts: 464
  • Distinguished Pistol Shot
    • View Profile
    • The Firing Line
Re: Recomended Primer?
« Reply #1 on: June 23, 2008, 11:21:02 am »
I have used both small and large Winchester and Federal.
No experience with any others.
Loaded well in excess of 100,000 rounds, could be 250K  (45, 38, 9mm)
I have not had a problem with either one, as long as machine is clean around the area, especially of powder residue.
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms shall not be infringed"

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1168
    • View Profile
    • Star Machine Works
Re: Recomended Primer?
« Reply #2 on: June 23, 2008, 02:52:31 pm »
I too use Winchester and Federal and have not had any problems with either.  I use Winchester mostly, but have to use Federal for a couple of my competition guns.   Federal will go off with a lighter strike.  I only use Federal when I have to.
Star Machine Works
NRA Patron Member

CDRT

  • Active Members
  • ***
  • Posts: 85
    • View Profile
Re: Recomended Primer?
« Reply #3 on: June 23, 2008, 04:30:00 pm »
I've used Winchester, Federal and CCI.  No problems with any of them.
Distinguished Pistol Shot

starman

  • Active Members
  • ***
  • Posts: 88
    • View Profile
Re: Recomended Primer?
« Reply #4 on: June 24, 2008, 11:22:28 am »
CCI  seem to be harder in the old days you would never use cci in a star. The Federal are the best for light trigger target guns. But Winchester are just fine too. Keep your star clean and do not try to go to fast and you will make great amo good luck and have fun       Pat  from   Kalifornia

Star73

  • Active Members
  • ***
  • Posts: 219
  • Distinguished Pistol Shot Bullseye Master
    • View Profile
Re: Recomended Primer?
« Reply #5 on: June 25, 2008, 03:53:42 pm »
I also have had good exp w/ Win & Fed. CCI's have given me trouble in large pistol. They have been just large enough in dia to feed stubbornly thru 2 of my 3 feed tubes. With the 3rd they drop but not 100%.

In the past they were also of inconsistent height (thickness?) & I used small washers to raise the feed mech to allow clearance. I have only used them due to necessity. For many yrs the old timers warned against using CCI's in progressive loaders.

Al that being said CCI small primers have been OK in my machines.

Ron