« previous next »
Pages: 1   Go Down

Author Topic: Taper crimp die  (Read 13600 times)

0 Members and 3 Guests are viewing this topic.

jtd

  • Active Members
  • ***
  • Posts: 7
    • View Profile
Taper crimp die
« on: October 03, 2012, 12:55:54 pm »
There is a .45 tapper crimp die on Ebay that does not look like any die I own or have used. Also, it is shown with a box that says Star Mass. I do not understand this. Is it a shortened die to use with a round ejector? Is it a Star product at all? I am sure there are several on here that have all the info on this. Please explain. Thank you very much for your help.
Logged

Stillwater

  • Active Members
  • ***
  • Posts: 38
    • View Profile
Re: Taper crimp die
« Reply #1 on: October 03, 2012, 02:00:16 pm »
Quote from: jtd on October 03, 2012, 12:55:54 pm
There is a .45 tapper crimp die on Ebay that does not look like any die I own or have used. Also, it is shown with a box that says Star Mass. I do not understand this. Is it a shortened die to use with a round ejector? Is it a Star product at all? I am sure there are several on here that have all the info on this. Please explain. Thank you very much for your help.

Interesting question that I would like to know the answer too...

Bill
Logged

cc656d

  • Active Members
  • ***
  • Posts: 159
    • View Profile
Re: Taper crimp die
« Reply #2 on: October 03, 2012, 03:04:58 pm »
IT will fit an older tool that had a small hole.
Logged
Distinguished pistol shot
2600 club
NIB Star
Benefactor member NRA
Life Member Va, Md, WVa, and Fl State Shooting Associations , Life OGCA

leatherguy

  • Active Members
  • ***
  • Posts: 20
    • View Profile
Re: Taper crimp die
« Reply #3 on: October 03, 2012, 05:03:13 pm »
The last position in an older HEAD had a .375" hole. It was not threaded. Marden was a company that made an after market TC that utilizes that hole. I have an older machine with one in it.
Logged
Pages: 1   Go Up
« previous next »