« previous next »
Pages: 1   Go Down

Author Topic: Up-Date On Part ID  (Read 9321 times)

0 Members and 1 Guest are viewing this topic.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Up-Date On Part ID
« on: September 05, 2011, 06:31:17 pm »
The Little Screw & Washer under the Base that stops the Primer Punch from dropping down to far below the
#12U* Steel Floor Base,
Description is as follows:: :D ;D

SCREW
Slotted Fillister = 6-32 x 6/32"

WASHER
Diameter = .375 OD
Hole = 3/8"
Thickness = .038 varies

"Now You Know Said GI Joe"
« Last Edit: September 11, 2011, 03:53:41 pm by askimball (Doc) »
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain
Pages: 1   Go Up
« previous next »