« previous next »
Pages: 1   Go Down

Author Topic: Shell Plate Thrust Nut  (Read 15066 times)

0 Members and 1 Guest are viewing this topic.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Shell Plate Thrust Nut
« on: March 14, 2011, 08:20:28 pm »
Does a Thrust nut that is adjusted down to Tight keep the shells from exiting using the Case Kicker ??? ???
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

NYKenn

  • Active Members
  • ***
  • Posts: 506
  • Distinguished Pistol Shot
    • View Profile
    • The Firing Line
Re: Shell Plate Thrust Nut
« Reply #1 on: March 14, 2011, 08:34:45 pm »
Yes it can. May bind on the rim, causing tightness.
Logged
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms shall not be infringed"

WWW.TheFiringLineNY.com

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Re: Shell Plate Thrust Nut
« Reply #2 on: March 14, 2011, 08:43:14 pm »
Thanks NYK
Thought so, I'll re-adjust....
« Last Edit: April 01, 2011, 02:07:48 pm by askimball »
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Re: Shell Plate Thrust Nut
« Reply #3 on: March 15, 2011, 04:25:15 pm »
I think I found the problem/'s, some of the shellplate shell cuts were pretty tight..Next I discovered that the #68U - Shell Floor Base Plug (Universal) wasn't level with the #12U - Steel Floor Base (Universal)
so, I'll have to address that situation later.........sigh.....
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

NYKenn

  • Active Members
  • ***
  • Posts: 506
  • Distinguished Pistol Shot
    • View Profile
    • The Firing Line
Re: Shell Plate Thrust Nut
« Reply #4 on: March 15, 2011, 06:45:18 pm »
I have found some differences in base plugs, particularly in the degree of taper.
If you have more than one, try mating it to the machine.

It does seem a little unusual in the shellplate being inconsistent. That is not Star like at all!
Logged
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms shall not be infringed"

WWW.TheFiringLineNY.com

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Re: Shell Plate Thrust Nut
« Reply #5 on: March 22, 2011, 12:40:47 am »
Some of the 10mm cases seem tight in the shellplate??? ???
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain
Pages: 1   Go Up
« previous next »