« previous next »
Pages: 1   Go Down

Author Topic: HULME TEMPLATE/JIG TO DRILL FOR A CASE FEEDER  (Read 10389 times)

0 Members and 1 Guest are viewing this topic.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
HULME TEMPLATE/JIG TO DRILL FOR A CASE FEEDER
« on: March 29, 2011, 02:25:10 pm »
Last step to finish the Phelps loader project ;D
  I need the following

Hulme offered a kit to locate, drill and tap the hole for the case feeder on older models.


JUST NEED A TEMPLATE (LOCATE) :)
« Last Edit: April 21, 2011, 06:25:57 pm by askimball »
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

Rolling Stone

  • Active Members
  • ***
  • Posts: 76
    • View Profile
Re: HULME TEMPLATE
« Reply #1 on: March 29, 2011, 03:53:52 pm »
Be extremely careful to get the hole the correct distance from the loading port or slot in the base because if this dimension is off a smidgen the plunger will hit and bind on the slots in the shell  plate. Getting the hole centered in the slot shouldn't be that big a deal.
Good Luck
RS
Logged

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Re: HULME TEMPLATE
« Reply #2 on: March 29, 2011, 03:58:50 pm »
Maybe not for you, BUT, still would like a TEMPLATE to be sure it's
in the Correct Spot.....
Logged
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain
Pages: 1   Go Up
« previous next »