« previous next »
Pages: 1   Go Down

Author Topic: Last Station Dimensions  (Read 11030 times)

0 Members and 1 Guest are viewing this topic.

varmintpopper

  • Active Members
  • ***
  • Posts: 299
    • View Profile
Last Station Dimensions
« on: May 19, 2012, 10:11:26 pm »
Measured the width of the opening where the Case rim exits the Base ( with a Kicker ) on the taper crimp station,  4 out of 5 openings measured .555 inch the other one measured .495 , Found this after setting up to load .44 mag,, Guess what ,the rim on a 44 mag is wider than the opening. Anyone have this problem before ??  I guess I can modify by grinding the opening larger, or swap the head to another base with a larger opening.

Good Shooting

Lindy
Logged

fc60

  • Active Members
  • ***
  • Posts: 493
    • View Profile
Re: Last Station Dimensions
« Reply #1 on: May 20, 2012, 11:52:53 am »
Greetings,

Not sure why one press has a smaller opening? However, since you have three other machines as a reference, I would be very tempted to get my small files out and "make the upgrade".

I do have a machine that will not accept a 45 AR case. The other machines work fine.

Cheers,

Dave
Logged

varmintpopper

  • Active Members
  • ***
  • Posts: 299
    • View Profile
Re: Last Station Dimensions
« Reply #2 on: May 20, 2012, 11:28:09 pm »
TY Dave
Perhaps I will Dremil it to fit a .44 Mag instead of swapping heads to another base.

Good Shooting

Lindy
Logged
Pages: 1   Go Up
« previous next »