« previous next »
Pages: 1   Go Down

Author Topic: hulme cleaning & maintenance  (Read 12142 times)

0 Members and 1 Guest are viewing this topic.

Kirk A

  • Active Members
  • ***
  • Posts: 64
    • View Profile
hulme cleaning & maintenance
« on: May 25, 2011, 11:00:03 pm »
Recently, my 3rd Star arrived -- a Universal varnished with years of oil. Since it was packaged is a dismantled state, I have taken the opportunity to learn about every screw and fastener as I clean and restore it, piece by piece, fastener by fastener.

I would like to similarly clean the Hulme case feeder, but I honestly cannot figure out how to disassemble it. So, I am your expert advice. What is the take-down technique for this? (This appears to be a later model, with the short bolt.)

Thanks,
Kirk
Logged
Distinguished Pistol
Distinguished Revolver

fc60

  • Active Members
  • ***
  • Posts: 493
    • View Profile
Re: hulme cleaning & maintenance
« Reply #1 on: May 26, 2011, 11:06:48 am »
Greetings,

The Hulme I possess come apart in this manner.

Slacken the setscrew in the end of the cylindrical pusher.
Remove the roller and pin on the side being careful the cylindrical pusher does not fly out.
Slowly remove the cylindrical pusher and spring.

Cheers,

Dave
Logged

Kirk A

  • Active Members
  • ***
  • Posts: 64
    • View Profile
Re: hulme cleaning & maintenance
« Reply #2 on: May 27, 2011, 07:45:33 am »
Terrific advice, Dave! In the recess of the plunger, I failed to notice the set screw behind a veneer of grime.

Thank you.
Logged
Distinguished Pistol
Distinguished Revolver

varmintpopper

  • Active Members
  • ***
  • Posts: 299
    • View Profile
Re: hulme cleaning & maintenance
« Reply #3 on: May 27, 2011, 03:47:33 pm »
The Instructions for installing the Hulme case feeder has at the bottom of the page the following statement:

"THIS DEVISE IS LUBRICATED WITH LUBRIPLATE, KEEP IT LUBRICATED"

Good Shooting

Lindy
Logged
Pages: 1   Go Up
« previous next »