Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - MikeA

Pages: « 1 2 3 4
Star Reloaders / Re: Brewster indexer installation help
« on: May 21, 2010, 04:02:59 am »
I have a Brewster mounted on one of my Star presses. I will take some pictures tomorrow and send
them to you.  One thing I did notice when checking out the Brewster was that it pushed on the shell case
high enough to cause the round to bind the shell plate,  I solved this by raising the press the thickness of two 1/4-20 washers at each base plate mounting holes between the base and what ever you have the Star mounted to.  If you glue the two washers together it makes the alignment easier.  This also gives the sizer/decapper room to work.  Here are some pictures of the Brewster.

Star Reloaders / Re: Help: I Lost my primer bar return spring
« on: May 17, 2010, 12:32:54 pm »
You might try McMaster-Carr on line, they show a 3/16 x. 02 x 1 3/4".  That was the only
one I looked at so there might be others with a longer length. $6.29 per 12. Try part #
9657K148        Good luck, MikeA.

Pages: « 1 2 3 4