Messages

1

Star Reloaders / Dies for turning

« on: December 28, 2009, 04:25:52 pm »

I know some people have turned down lee dies for Star presses, what did you do for the seating die?  It looks like if I cut it to a 11/16 thread I will break through to the threads for the bullet adjuster.

2

Star Reloaders / Any interest in new star type reloader?

« on: December 27, 2009, 07:04:48 pm »

I've been staring at a star for a while now and was wondering how much interest there would be in a newly manufactured star with upgrades and how much people would be willing to pay for it.  The upgrades I think should be included are:

No shell, no powder.
Reversible for right or left hand.
7/8-14 dies.
Adjustable powder bars.
Make it so you can use whatever powder measure you desire.
Hulme type case feeder standard or being able to use one from someone else.
Change the ergonomics.

Any suggestions or ideas, value?

3

Star Reloaders / Tap toolhead or turn down dies?

« on: October 29, 2007, 10:11:57 pm »

I have acquired a star without dies and was wondering which works better, rethreading the toolhead to 7/8-14 or turning dies down to a 11/16 thread.  Any thoughts are appreciated.