1
Star History / Star Tool Head heavy lifting
« on: August 05, 2021, 10:54:09 pm »
Star tool head used out of necessity for lifting 560 lbs. of Evinrude outboard motor , yes !
News:
Your active membership and involvement is what makes this forum work. Thank you very much!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1
2
Star Reloaders / Re: Taper crimp die post end type
« on: October 23, 2020, 08:03:27 am »
Wealth of information on this site !
Yes, my taper crimp post end die in the photo is for 45 cal. I'm using SWC lead bullets for target loads, and they are accurate.
Yes, my taper crimp post end die in the photo is for 45 cal. I'm using SWC lead bullets for target loads, and they are accurate.
3
Star Reloaders / Re: Taper crimp die post end type
« on: October 22, 2020, 09:30:46 pm »
Does anyone know who made these post end taper crimp dies?
The one I have has a stamp marking "patent pending".
The one I have has a stamp marking "patent pending".
Pages: 1