StarReloaders.com Discussion Forum

Star Reloaders Discussion Forums => Star Reloaders => Topic started by: aussie.32star on December 17, 2008, 06:16:27 pm

Title: Star Machine Works
Post by: aussie.32star on December 17, 2008, 06:16:27 pm

Ga-day.

Can any one inform me if the Star is back in production. I am confused, I have read on other web sites that the Star is being produced again(2008). I am dead keen on getting another in .32 S&W long with a .312 necker/bell mouth. Set me straight on this subject.

Brian
Aussie.32star 
(down under)

Title: Re: Star Machine Works
Post by: rbwillnj on December 17, 2008, 10:39:32 pm

Star is not back in production, however, C-H Tool and Die http://www.ch4d.com/ has made a run of dies for the Star Reloader.   Don't know if they have any left, but they did make dies for 32 S&W Long.   Richard Daniels in Connecticut is making Shell plates.  You should be able to find contact information for Richard Daniels elsewhere on this forum.

Title: Re: Star Machine Works
Post by: starman on December 18, 2008, 03:15:30 pm

Lee also makes dies for the star in carbid last time I check it was 32 dollars for sizing die  it is a lee die with a 11/16 x 24 thread good luck

Title: Re: Star Machine Works
Post by: 45 ACP on December 18, 2008, 04:50:16 pm

Is Lee making 11/16 x 24 thread 3 die sets in various calibers? Anyone know? Thanks, Pete