StarReloaders.com Discussion Forum

Star Reloaders Discussion Forums => Star Reloaders => Topic started by: johnfreeman on June 22, 2013, 02:08:36 pm

Title: Hulme case feeder question
Post by: johnfreeman on June 22, 2013, 02:08:36 pm

Bruce made me a new set of rollers and the pin that actuates the Hulme case feeder. My question is what holds this pin/roller assembly inside of the piston itself? It looks like the front of the piston is threaded. Is there normally a set screw that's inserted in there to hold the "axle" for the rollers in place?

Thanks
John

Title: Re: Hulme case feeder question
Post by: fc60 on June 22, 2013, 03:15:40 pm

Greetings John,

You are correct. There should be a set screw located in the threaded hole in the front of the piston.

You position the axle and roller so the roller spins freely and snug the set screw onto the axle.

Cheers,

Dave

Title: Re: Hulme case feeder question
Post by: johnfreeman on June 22, 2013, 06:58:16 pm

Thanks Dave (and thanks for the 9mm dies!)

John