StarReloaders.com Discussion Forum

Star Reloaders Discussion Forums => Stars Want to Sell/Want to Buy => Topic started by: askimball (Doc) on October 18, 2011, 12:24:43 am

Title: HULME BOLT
Post by: askimball (Doc) on October 18, 2011, 12:24:43 am

Got one more Hulme to install, BUT, I need the Bolt to install it to the #12U Base.. :D
Anybody help me out.. ??? ??? ;D

It's  5/16"- 24 x 7/8"

Title: Re: HULME BOLT
Post by: Lifetyme on October 18, 2011, 08:32:29 am

Hi.

I'm sorry but I don't recall the bolt size offhand.  I have purchased them in the past from screw and bolt stores locally.  You might check your local yellow pages.

Regards,

Bob

Title: Re: HULME BOLT
Post by: cc656d on October 18, 2011, 12:54:33 pm

You might take one off of one of your tools and take it to the hardware. I am sure they can match it.

Title: Re: HULME BOLT
Post by: askimball (Doc) on October 18, 2011, 06:33:04 pm

OK, I'll do that......... :D

Thanks everybody......... ;)

Title: Re: HULME BOLT
Post by: rbwillnj on October 19, 2011, 02:23:00 pm

The bolt that attaches the Hulme to the reloader base has a 5/16-24 thread.   The length of the bolt depends on the style/vintage of the Hulme case feeder.   The most common Hulme uses a 2 1/2" long bolt.   The old style uses a 5/8" long bolt.   There is an intermediate style that looks like the newer ones, but has a large hole through the side (you sent me a picture of one).   I think this one also uses a 5/8" long bolt, but I'm not sure, and don't have one at this moment to check.

Title: Re: HULME BOLT
Post by: Marshal Kane on March 26, 2012, 04:11:43 pm

Quote from: rbwillnj on October 19, 2011, 02:23:00 pm

. . .There is an intermediate style that looks like the newer ones, but has a large hole through the side (you sent me a picture of one).   I think this one also uses a 5/8" long bolt, but I'm not sure, and don't have one at this moment to check.

I have one and you are correct.  It is a 5/8" long bolt.