StarReloaders.com Discussion Forum

Star Reloaders Discussion Forums => Star Reloaders => Topic started by: varmintpopper on October 16, 2011, 06:29:50 pm

Title: Hulme Case Feeder
Post by: varmintpopper on October 16, 2011, 06:29:50 pm

A used Hulme Case Feeder Just Sold on Ebay for $193.59, and without tubes.  With prices like that, it might pay someone to tool up and make a few of them !

Good Shooting

Lindy

Title: Re: Hulme Case Feeder
Post by: angus6 on October 16, 2011, 06:35:51 pm

Isn't Rich making them ?

Title: Re: Hulme Case Feeder
Post by: askimball (Doc) on October 17, 2011, 09:10:20 pm

YES HE DOES.. :D ;D
(Barrel tester) Richard Daniels

WELL WORTH IT.. :D :o

*I also have one*

Title: Re: Hulme Case Feeder
Post by: hemitom on November 29, 2011, 11:52:44 pm

...and I have one of Rich's case feeder units - superb craftsmanship.

Hemitom

Title: Re: Hulme Case Feeder
Post by: LeupoldMRK4 on November 30, 2011, 04:21:38 pm

I think Rich Daniels sells them for $150.00 Complete.

Title: Re: Hulme Case Feeder
Post by: askimball (Doc) on November 30, 2011, 05:34:25 pm

ALSO
'rbwillnj' makes the listed below........... ::)

I am currently making a run of Hulme top plates.   I will initially be making the standard M3 (for 45 ACP, 40 S&W, 38 Super and 38 special) the M3A for 41 magnum, 44 magnum and 45 Long Colt as well as top plates for 9MM and .380.

Eventually I will get around to making a copy of the Dillon Top Plate for loading .223 and 30 Carbine.