StarReloaders.com Discussion Forum
Star Reloaders Discussion Forums => Star Reloaders => Topic started by: askimball (Doc) on September 09, 2011, 09:29:30 pm
-
I received a email from a Jon Kay, couldn't find him in the name register...... ???
I'm going to Post a picture he emailed me.. :D
His email address is: fishcop021(at)yahoo(dot)com
Here is a comparison picture of Dave's custom Potter sizing die in .41 Magnum (left), and an original Potter .38 Special sizing die (right).
-
I apologize for the "non-Star" post about the Potter, but since it is "grew up" in the Star era, I thought it might be interesting to some.
The 41 magnum die was made by member fc60 (Dave). I had purchased a Potter 41 Magnum seating die from a member of the Antique Reloading Tool Collectors Assoc., and needed a sizing die and shell plate to complete the die set. Dave took up the challenge, and made a beautiful die for me. He was very generous with his machining knowledge and commuicated often during the process.
My original thread is here: http://www.starreloaders.com/forum/index.php?topic=1382.0
PS: If any knows of others who may have full or partial die sets for Potters, Potter parts or presses with an interest to sell, or just to exchange information, please pass this along to them.
Many Thanks, Jon
-
Sorry Jon
I couldn't find you name in the MEMBERS List :-[
I recognize your Form handle now, a Prominent Member.................... :)
-
Sorry Jon
I couldn't find you name in the MEMBERS List :-[
I recognize your Form handle now, a Prominent Member.................... :)
Thanks for posting the picture Doc! Jon.