StarReloaders.com Discussion Forum

Star Reloaders Discussion Forums => Star Reloaders => Topic started by: askimball (Doc) on June 14, 2011, 09:07:18 pm

Title: HULME ATTACHMENT SCREW / BOLT
Post by: askimball (Doc) on June 14, 2011, 09:07:18 pm

Can anyone Verify the thread of the Screw that attaches the Hulme case feeder to
the Star... :P :-[ ???

I show  '5/16"-24, is this correct......... ???

Title: Re: HULME ATTACHMENT SCREW / BOLT
Post by: Rolling Stone on June 14, 2011, 10:45:04 pm

That's what the directions said to use.

Title: Re: HULME ATTACHMENT SCREW / BOLT
Post by: askimball (Doc) on June 15, 2011, 03:44:51 pm

After researching Drill sizes, I'm assuming that Hulme wanted a TIGHT thread
fit.......... :D
So I'll go with the 17/64" drill bit...........

Thanks everybody for the help.... ;D