Author Topic: DIFFERENCE BETWEEN #18 & #18T  (Read 5771 times)

0 Members and 1 Guest are viewing this topic.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
DIFFERENCE BETWEEN #18 & #18T
« on: February 15, 2011, 01:19:08 pm »
Dumb question, :-[
But, is there a quick/evident visual check to tell the difference between the #18 Roll Crimp Die and the #18T Taper Crimp Die.. ??? :-[

And another question, :-[ 
Is there a drawing/template that shows the Die layout on the Head.. :-[ ???

Just a though for any newbies........ ::)
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

fc60

  • Active Members
  • ***
  • Posts: 480
    • View Profile
Re: DIFFERENCE BETWEEN #18 & #18T
« Reply #1 on: February 15, 2011, 08:37:24 pm »
Greetings,

All the Star Dies I have encountered have the following characteristics...

The #18 has always had a Roll Crimp and the top of the die is threaded for a seating punch.

The #18T generally is about 2.0" long and has no threaded hole at the top. Often it is the bullet diameter clearance all the way through.

I have deviated from the above by machining a Roll Crimp die with no threads for the seating stem. I try to mark the end of the die to distinguish this variation.

In the past, if I wanted to roll crimp in the last station, I would order a spare #18 die from Star. 

By the way, the #18T style dies are easier to clean than the #18 dies. I just run a Bore Snake © through the die once and a while.

Cheers,

Dave