286
Star Reloaders / Re: Reloading bench ideas?
« on: August 20, 2009, 09:24:32 pm »
When my father first got his Star and began reloading he had a similar setup. In was in the basement on a studded but unfinished wall. I was on the "other side" placing bullets and removing rounds if .45. (The .38 fell through)
I still have the Star mounted on the same board in my house, Just no rear access!
Board is drilled for primers to fall through into a drawer, and finished rounds into a plastic bin in the drawer.
weighted pedestals that Bruce uses are good too.
Sometimes simplest and basic is best.
If I get a chance will do measurements and dimensions, but I think it began as a 2 x 10 or 12.
I still have the Star mounted on the same board in my house, Just no rear access!
Board is drilled for primers to fall through into a drawer, and finished rounds into a plastic bin in the drawer.
weighted pedestals that Bruce uses are good too.
Sometimes simplest and basic is best.
If I get a chance will do measurements and dimensions, but I think it began as a 2 x 10 or 12.