Author Topic: WTB: vintage indexer as shown in the pic  (Read 5882 times)

0 Members and 1 Guest are viewing this topic.

z4lunch

  • Active Members
  • ***
  • Posts: 48
    • View Profile
WTB: vintage indexer as shown in the pic
« on: November 03, 2018, 05:48:01 pm »
Steve here... Looking for one of these vintage indexers like the one in the pic I attached... just would like  try one  and have for my collection
Let me know
Thank you
Steve

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1216
    • View Profile
    • Star Machine Works
Re: WTB: vintage indexer as shown in the pic
« Reply #1 on: November 03, 2018, 07:51:50 pm »
Have to pull them out of the box, but I have a bunch of those.

Bruce
Star Machine Works
Star, the original blue Press.  Made by machinist, not machines.
www.StarMachineWorks.com

824tsv

  • Active Members
  • ***
  • Posts: 37
    • View Profile
Re: WTB: vintage indexer as shown in the pic
« Reply #2 on: November 04, 2018, 06:53:20 am »
Bruce, can you advise who made that one and how it works?

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1216
    • View Profile
    • Star Machine Works
Re: WTB: vintage indexer as shown in the pic
« Reply #3 on: November 04, 2018, 02:35:53 pm »
I think they may have been made by several companies.  I don't believe that any I have encountered had a name or label on them, but my notes indicate that the one pictured below was made by Capital(?).

They fit on Phelps Reloaders and older Star reloaders with the one piece aluminum base.   They require modification in order to be used on later (post 1962) Star reloaders with the two piece aluminum base.


Not shown in the pictures, there is a long set screw that replaces the square head bolt that clamps the operating handle.   Attached to that set-screw is a tab with the other end of the wire attached.   When the handle is pulled, it pulls on the wire that goes around the large pulley, activating the indexer tab which pushes the cartridge from the seating station to the taper crimp station.   


There is a spiral clockwork spring under the big pully which is often broken.   I have seen a number of these where the owner has added a coiled spring to compensate for the broken clockwork spring.

These indexers cause the same wear to the steel base as a Brewster or Hoyer Indexer, but in a different location.


Bruce Williams

« Last Edit: November 04, 2018, 02:38:24 pm by rbwillnj »
Star Machine Works
Star, the original blue Press.  Made by machinist, not machines.
www.StarMachineWorks.com

824tsv

  • Active Members
  • ***
  • Posts: 37
    • View Profile
Re: WTB: vintage indexer as shown in the pic
« Reply #4 on: November 04, 2018, 05:45:51 pm »
Excellent as always Bruce! Thanks very much for the info!!!

wayne

  • Active Members
  • ***
  • Posts: 43
    • View Profile
Re: WTB: vintage indexer as shown in the pic
« Reply #5 on: March 27, 2019, 03:50:08 pm »
I had one of these it is a Phelps product.It worked fine until the spring broke.I used a spring loaded belt loop type key holder with much better results.