Author Topic: threads  (Read 5514 times)

0 Members and 1 Guest are viewing this topic.

GeraldChainsaw

  • Active Members
  • ***
  • Posts: 86
    • View Profile
threads
« on: December 01, 2017, 05:54:24 pm »
does any one know?,  thread size on star dies compared to maybe RCBS,  thanks

joe3320

  • Active Members
  • ***
  • Posts: 39
    • View Profile
Re: threads
« Reply #1 on: December 01, 2017, 06:14:32 pm »
Hi Gerald,

Thread Size for Star Reloading Press is (11/16-24 ) compared to  the Industry Standard which is (7/8"-14).
However, one can rework the heads to take the Standard dies.
Hope this helps.

Joe

fc60

  • Active Members
  • ***
  • Posts: 480
    • View Profile
Re: threads
« Reply #2 on: December 01, 2017, 09:12:51 pm »
Greetings,

Star threads are most interesting.

Dies are 11/16-24

Expander Plug is 1/2-27

Powder Hopper thread is a strange tapered 27 TPI. (I made a custom tap for Bruce Williams to clean up threads damaged with aftermarket straight threads.)

Seating die stems are 5/16-32 for 38 caliber and smaller. For the larger calibers, 3/8-24 is used.

All taps can be purchased from McMaster-Carr. With the exception of the Powder Hopper thread. Never did find one for sale via the Internet.

If you do decide to modify the tool head, make sure the die will clear the shell plate. 38 and smaller have a 5/8" die clearance while the larger ones are 3/4".

Enlarging the holes is not a job for the drill press. It needs to be done on a Bridgeport or similar machine capable of holding the hole locations.

Personally, I would not modify a Star Tool Head. I would buy a Dillon instead.

Most of the Phelps shell plates I have seen may work with 7/8-14 dies. However, the center hole is larger than the Star 1.247" diameter and may rattle around a bit on a Star machine.

Cheers,

Dave