Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - tony barone

Pages: « 1 2 3 4 5 6 7 8 9
Loading Data & Reloading Procedures / Re: Sticking Shell Plate
« on: October 19, 2007, 12:09:05 pm »
 As per Star instructions.Keep all parts subject to wear, including cam that operates angle lever, slightly lubricated [except the powder carrier]. Lubricate primer slide with small amount of dry graphite only.

Loading Data & Reloading Procedures / Re: Sticking Shell Plate
« on: October 18, 2007, 05:29:11 pm »
 I would pull the tool head and shell plate then clean the floor base and shell plate. Reassemble and turn the shell plate thrust nut down fully and back it off 1/8 turn and tighten the clamping screw. Lightly lube the area between the column shaft and shell plate. Also check that the steel ball is free to rotate.

Star Reloaders / Re: Star Machine Works web page
« on: June 02, 2007, 07:15:21 pm »
No one has been able to contact Star for quite some time. I would say that Star is out of business.

Star Reloaders / Re: Phelps indexer?
« on: January 02, 2007, 10:18:32 pm »
I have all of the MA Systems attachments made for the Star. The case collator, shell plate indexer and case ejector. They work flawlessly. The problem is they no longer make these attachments.

Star Reloaders / How does it work?
« on: August 25, 2005, 03:06:40 pm »
MA-Systems is located in Pryor OK. Their number is 918-824-3705

Star Reloaders / How does it work?
« on: August 22, 2005, 08:44:03 pm »
MA Systems markets all the attachments to make the Star fully progressive. I have been using them for years and have loaded ten's of thousands of rounds without a problem.

Star Reloaders / primer system
« on: April 26, 2005, 02:12:11 am »
Hi Les

I just found this forum and I!m happy to see that I am not the only one enjoying loading on the star loader. You should not be shaving brass at the primer loading station. There is an adjustment that can be made at that station in your instruction manual. I have a universal loader with m/a system case collater,roto-ease,eject-ease and roller ease handle. Being an IPSC shooter i have loaded 100,000+ rounds on my machine practically trouble free. It produces factory like ammo. I hope you can solve your problem.

Pages: « 1 2 3 4 5 6 7 8 9