Author Topic: Powder Drain Block  (Read 10883 times)

0 Members and 1 Guest are viewing this topic.

malewisoak

  • Guest
Powder Drain Block
« on: November 02, 2005, 08:40:20 pm »
Can  someone  tell  me   where  I  can  find  some  information  of  a  
"Powder Drain Block  "    It  is   attached  to  a  Star  Reloader  

Thanks            Dave

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1216
    • View Profile
    • Star Machine Works
Powder Drain Block
« Reply #1 on: November 02, 2005, 09:54:20 pm »
What information are you looking for?  I have one that came on one of my Star Reloaders.   It says Pat. Pend. on it, but doesn't have a company name on it.
Star Machine Works
Star, the original blue Press.  Made by machinist, not machines.
www.StarMachineWorks.com

malewisoak

  • Guest
Powder Drain Block
« Reply #2 on: November 02, 2005, 11:18:33 pm »
rbwillnj       I  dont  have  a  powder  drain  block. I  guess  I  shou;ld   have  said  " it  attaches  to  a  reloader"  Was  just  looking   for  info  on  one .  Are  they   available   and  where  ????

Thanks  for   reply  
Dave

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1216
    • View Profile
    • Star Machine Works
Powder Drain Block
« Reply #3 on: November 03, 2005, 07:43:51 am »
I have no idea where you could find one.  I have one that came on one of my machines, but I stopped using it.  I found it was easier to just remove the tool head and flip it over to empty the powder magazine.

I use a "hairpin cotter pin" to retain the lower link pin.  Just unhook the tool head spring, press out the taper pin, and pull out the lower link pin, and you can pull of the crank shaft assembly and tool head in seconds.

While you have it apart, its not a bad idea to remove the thrust nut and clean up the floor base and primer assembly.
Star Machine Works
Star, the original blue Press.  Made by machinist, not machines.
www.StarMachineWorks.com

TDO'NEILL

  • Active Members
  • ***
  • Posts: 52
    • View Profile
Powder Drain Block
« Reply #4 on: November 05, 2005, 07:24:07 pm »
Powder Drain Blocks are available through. ( Last year they were $45.00 )

Maurice Lewis
P.O. Box 61
Ahwahnee, CA 93601-0061

Maurliew<maurilew          [no e-mail]@.net
TDO'NEILL

TDO'NEILL

  • Active Members
  • ***
  • Posts: 52
    • View Profile
Powder Drain Block
« Reply #5 on: November 05, 2005, 07:28:36 pm »
Please correct above post to read:  Maurilew<maurilew     [no e-mail]@.net
TDO'NEILL