Messages

16

Star Reloaders / Hulme feed tube question

« on: March 30, 2012, 10:47:01 am »

Did the Hulme feed tubes come in different diameters or is there just one universal size?  Reason I ask is do you need different tubes for e.g. .45 ACP vs. .38 Special?  I'm using 1/2" tubing for .45 ACP so is that too big for .38 Special?  Thanks in advance for any comments and advice  

17

Star Reloaders / Re: rbwillnj (Bruce) is a great guy and does awesome work!

« on: March 30, 2012, 10:37:54 am »

Just got my M3 Hulme case feeder top plate.  The workmanship and materials is awesome!  Exact duplicate of the original part!  Would not hesitate to buy anything I need from Bruce.

18

Stars Want to Sell/Want to Buy / Re: WTS Hulme Top Plates M3, M3A and 9MM

« on: March 30, 2012, 10:31:07 am »

. . . Actually, I have all the materials to make the tube holders, just haven't had time to work on them.   I have to figure out a good way to bend the flat spring stock.

Bruce

Be sure to let us know when they are available

19

Stars Want to Sell/Want to Buy / Re: WTS Hulme Top Plates M3, M3A and 9MM

« on: March 29, 2012, 06:14:50 pm »

Karl,   Email Sent

I just received my M3 top plate today and I can honestly say that I'm blown away by the workmanship and quality of materials!  It's even got the M3 marking where it should be.

Anyone needing a top plate can take it from me that Bruce turns one out that is without equal!  Thank you Bruce for an amazing product.  Now if you'll only think about turning out a Hulme style feeder tube clamp . . .      

20

Stars Want to Sell/Want to Buy / Re: HULME BOLT

« on: March 26, 2012, 04:11:43 pm »

. . .There is an intermediate style that looks like the newer ones, but has a large hole through the side (you sent me a picture of one).   I think this one also uses a 5/8" long bolt, but I'm not sure, and don't have one at this moment to check.

I have one and you are correct.  It is a 5/8" long bolt.

21

Stars Want to Sell/Want to Buy / Re: WTS Hulme Top Plates M3, M3A and 9MM

« on: March 26, 2012, 04:00:33 pm »

Still have some available.

Would like to buy an M3 and if you have any, a tube clamp.

karl dot young one at cox dot net