Topics

1

Star Reloaders / .44 magnum powder charge

« on: March 25, 2023, 03:54:39 pm »

would like to throw 22 grains of 2400 on the Star.Is there a taller powder bar that will do it?

2

Stars Want to Sell/Want to Buy / .38/.357 bullet seating die and seating punch

« on: February 21, 2017, 03:51:05 pm »

I need a .38/.357 bullet seating die

3

Stars Want to Sell/Want to Buy / Moon / Ray Vin case kicker

« on: November 07, 2015, 02:05:58 pm »

Would like to buy a Ray Vin case kicker,I have tried their site with no luck.Appreciate advice.

4

Star Reloaders / MA system case feeder spring install

« on: April 13, 2015, 12:40:51 am »

I was fitting a new tube to my MA case feeder and removed the screw on the side,the spring popped out and I have not figured out how to put it back in.Any help greatly appreciated

5

Stars Want to Sell/Want to Buy / Need a .38 RN seating stem and a 9mm powder drop tube

« on: March 07, 2015, 08:49:03 pm »

I need a .38 RN bullet seating stem and a 9mm powder drop tube.

6

Stars Want to Sell/Want to Buy / powder drop tube 9mm

« on: October 05, 2014, 09:34:13 pm »

I damaged the drop tube in my 9mm tool head,flared it on a full metal jacket round nose.Any available somewhere?

7

Star Reloaders / primer feeder misalignment

« on: April 20, 2014, 01:20:57 pm »

The primer slide on my star.38 universal does not seem to align properly,it seems the primer catches on one side of the case during seating and then snaps into position leaving a visible scuff or bend on the edge of the primer.There does not appear to be any appreciable wear on any of the affecting parts.I've changed the primer slide itself which didn't cure anything.

8

Stars Want to Sell/Want to Buy / taper crimp 30 carbine

« on: November 16, 2013, 11:47:45 pm »

I have just aquired a Star tool head in .30 carbine,I have taper crimp dies on my other tool heads and wonder if it would be desirable if one is available for the 30 carbine

9

Loading Data & Reloading Procedures / difficult functioning with 9mm tool head

« on: November 06, 2012, 09:11:49 am »

I recently purchased and installed a 9mm tool head on my Star and the sizing is extremely difficult.How should the die be installed in relation to the shell holder?And how far down to the head of the case is necessary to adequately size for functioning?

10

Star Reloaders / powder drop

« on: August 13, 2011, 08:47:08 pm »

How do I contact Bruce Williams,I need to have powder drop tube made.