Author Topic: Brewster indexer installation help  (Read 5661 times)

0 Members and 1 Guest are viewing this topic.

model2965

  • Active Members
  • ***
  • Posts: 11
    • View Profile
Brewster indexer installation help
« on: May 10, 2010, 05:34:53 pm »
Can anyone send me the installation instructions or pictures of how to mount my indexer. I believe it is a Brewster but I am not sure.

MikeA

  • Active Members
  • ***
  • Posts: 53
    • View Profile
Re: Brewster indexer installation help
« Reply #1 on: May 21, 2010, 04:02:59 am »
I have a Brewster mounted on one of my Star presses. I will take some pictures tomorrow and send
them to you.  One thing I did notice when checking out the Brewster was that it pushed on the shell case
high enough to cause the round to bind the shell plate,  I solved this by raising the press the thickness of two 1/4-20 washers at each base plate mounting holes between the base and what ever you have the Star mounted to.  If you glue the two washers together it makes the alignment easier.  This also gives the sizer/decapper room to work.  Here are some pictures of the Brewster.
Mike

MikeA

  • Active Members
  • ***
  • Posts: 53
    • View Profile
Re: Brewster indexer installation help
« Reply #2 on: May 21, 2010, 12:00:12 pm »
Here are additional pictures as promised....MikeA
If you have any questions feel free to contact me.

model2965

  • Active Members
  • ***
  • Posts: 11
    • View Profile
Re: Brewster indexer installation help
« Reply #3 on: May 21, 2010, 08:12:09 pm »
Thanks that helps alot :)

Star73

  • Active Members
  • ***
  • Posts: 219
  • Distinguished Pistol Shot Bullseye Master
    • View Profile
Re: Brewster indexer installation help
« Reply #4 on: June 21, 2010, 12:36:42 am »
When installing these things thersa point where you must use your 3rd hand.
Ron