Author Topic: Brass "Y" powder dump  (Read 10547 times)

0 Members and 1 Guest are viewing this topic.

Jim Mc

  • Active Members
  • ***
  • Posts: 6
    • View Profile
Brass "Y" powder dump
« on: October 05, 2014, 07:10:32 pm »
Anyone know who made this Brass "Y" style powder dump?
Thanks, Jim Mc

333OKH

  • Active Members
  • ***
  • Posts: 153
    • View Profile
Re: Brass "Y" powder dump
« Reply #1 on: October 05, 2014, 07:28:17 pm »
I have never seen one like that, George.
George Tucker
NRA Life Member
USMC Life Member

Welsh Rifleman

  • Active Members
  • ***
  • Posts: 47
    • View Profile
Re: Brass "Y" powder dump
« Reply #2 on: October 06, 2014, 10:20:10 am »
I believe I got one like that from Richard Daniels (aka - Barrel Tester).....
George
NRA Patron
American Single Shot Rifle Association
Texas State Rifle Association
Single Action Shooting Society

Jim Mc

  • Active Members
  • ***
  • Posts: 6
    • View Profile
Re: Brass "Y" powder dump
« Reply #3 on: October 12, 2014, 07:21:12 pm »
Thanks for the info George, after you posted I saw a listing on eBay from Richard, looks like he's making a few again only with a brass screw in plug instead of the red cap. It works well.
Jim Mc

maurilew

  • Active Members
  • ***
  • Posts: 33
    • View Profile
Re: Brass "Y" powder dump
« Reply #4 on: October 15, 2014, 07:20:42 pm »
Very nice unit.
However, there appears to be an area mentioned in ad,on ebay, about left over powder having to be taken care of after reloading stops. A total seperate function in its self,using another case,and another pull on handle
Is there any estimate of how much powder is left in the brass tube. Will one case hold it all?

Maurilew  aka  "Ma"
maurilew

Jerry Lehrer

  • Active Members
  • ***
  • Posts: 37
    • View Profile
Re: Brass "Y" powder dump
« Reply #5 on: February 04, 2015, 04:12:31 pm »
Maurilew makes a very nice powder drain device.

Jerry

Jerry Lehrer

  • Active Members
  • ***
  • Posts: 37
    • View Profile
Re: Brass "Y" powder dump
« Reply #6 on: February 26, 2015, 07:17:39 pm »
Very few of the valves, dumps etc permit you to remove and replace a filled powder reservoir safely.

Scott Lorentz made a beautiful shut-off valve that replaced the powder slide top.   But that is all it did.

I made a powder reservoir with a slide valve on the bottom.  Star refused to endorse it because it was not idiot-proof.  I pot a tiny
cotter pin in the valve to lock it open.  I have used it for 40 years.

Jerry Lehrer

Scott L

  • Active Members
  • ***
  • Posts: 36
    • View Profile
Re: Brass "Y" powder dump
« Reply #7 on: March 14, 2015, 05:18:41 pm »
Here's the simple shut-off I made that Jerry mentioned.
Scott