Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - maurilew

Pages: 1
1
Stars Want to Sell/Want to Buy / Powder Drain/Shutoff
« on: March 07, 2015, 08:55:52 pm »
Reloader Forum;
Time to update previuos ad. Due to space usage,will be brief.

It replaces top half powder housing. Once in place there no further modification to loader.
, there is a cross slide.when in place to load it sits directly on brass powder slide.
When extended outward it move powder to drain position directly over down tube.Tube at this time is blocked by expandable plug. At this time there is no powder other than charge in bar ready to drop into last case to be loaded.
 
$55.00 +$3.25 s/h     Additional info will be available upon request at mlewis at sti dot net 559-683-5354

Regards to all     maurilew   aka "Ma"

2
Loading Data & Reloading Procedures / Harvey Protex Bullets ???????
« on: January 17, 2013, 06:56:51 pm »
Has anyone out there experimented with this bullet ?
Found a box of washers, mould with handles in a pile of gift material l got the other day. Don,t they go way back in reloading history?

Gratfull for any info   Maurilew "Ma"

3
Loading Data & Reloading Procedures / 38 Sp. Peters Cases
« on: December 09, 2010, 11:30:38 pm »
Have quite abunch of Peters cases with large primer holes. these are loaded rnd nose 38,s. and seem to be moderate in power. shot a few extras but hanging on to full boxes
 any one have some info on them?

4
Star Reloaders / need for powder drain ????
« on: November 17, 2010, 01:20:37 am »
NYKENN;
 Found one of ur questions on an old post. It is a good one.
 Since l have made and sold some to members of forum, will try to answer
 Started as a method of saving powder when time came to change/empty powder.
 Realy goofed up on first go around. Then the idea of  no powder being left between the powder slide bar and  bottom of powder magazine,became a question. It had to removed by what ever method available. Then the question of the slotted screws holding the housing down,becoming worn by a sloppy screwdriver being repeatedly used. The changing of powder slides can be done without removing top of housing. When only the amount of powder needs to be changed,like 2.7 grs wadcutters to 3.5 round nose .38,s. Use 10/32 allenheads instead.
 Safety factor; possibly no powder. That l leave up to the loader. with or without drain ; his/her problem.
 Convenience; It can be a drain or a cutoff, by inserting a plug in drain tube, remove when putting powder back in container.
 Simplisity in use and construction was my main objective.
 Cost is another .
 Have tried to attach pictures to this forum, but that is one point where l,m stumped

regards; maurilew  (Ma)
 

5
Star Reloaders / posting images
« on: December 01, 2009, 05:38:27 pm »
Can   anyone   tell   me   how   to  post   an  image in  a   new  post 
I  have  just  attached  image   but  dont  know  if  it  will  work

Pages: 1