Author Topic: Rotate Machine "Off Square"  (Read 8600 times)

0 Members and 1 Guest are viewing this topic.

gunsmither

  • Active Members
  • ***
  • Posts: 5
    • View Profile
    • http://www.gunsmithertools.com
Rotate Machine "Off Square"
« on: March 21, 2004, 02:17:48 pm »
Thanks for the reply Ray Jones. I have rotated the base about 75 - 90 degrees counterclockwise, and it is way easier for me to seat a bullet. With my friends Arthritis condition, this will most likely be better for him too. With an offset handle, or reversed handle, he should be better able to seat bullets.

I will bend a new offset handle from barstock as you describe, and give it a try. Definately easier than reversing the handle idea of mine! This may be just the ticket for my buddy. Thanks very much for the idea. I'll report back on it after I make a new handle shaft; don't want to screw up the original.

Safe Shooting Friends! - Joe  :)