Star Reloaders Discussion Forums > Star Lubricator & Resizers

Star Luber gaskets

<< < (3/3)

rbwillnj:

--- Quote from: varmintpopper on June 11, 2023, 12:42:26 am ---Hi Bruce
Take a look at the edge of Your Hycar washer with about twenty power magnification, I'm sure You will find a cloth material there like You find in Belting, All that I've delt wth Have this.

--- End quote ---

Lindy,   The Hycar washers I have are molded, not stamped.  There is no cloth belting.   It wouldn't surprise me if they stamped them out of belting at some point in the past.   As I said earlier, I recall a leather washer on a very old Star lubesizer.

In the pictures I posted above, the two pictures are the top and bottom of the same washers.   You can see how the "rubber" is molded around the metal piece in the center.

Bruce Williams

varmintpopper:
Hi Bruce

The washers I'm refering to came with a new sizer/luber purchased in 1956. I'm Guessing there have been a few changes over the Years.

Good Shooting

Lindy

Navigation

[0] Message Index

[*] Previous page