Star Reloaders Discussion Forums > Star Lubricator & Resizers

Star Luber gaskets

(1/3) > >>

Gwalloch10x:
I need to replace all gaskets in my luber sizer.  Does anyone know the size, part number, etc.?

fc60:
Greetings,

The only "gasket" I know of is the #107 Hycar Washer.

Magma redesigned it and it is now a machined piece of plastic.

I was never able to find the source of the original Hycar Washers.

They resemble "cup seals"; but, again, I was not able to find the right size.

Cheers,

Dave

varmintpopper:
Years ago I discovered a source for the Exact replacement of the Hycar Washer in the "Home Depot Plumbing Department". I bought in excess of My needs, bagged them, tagged them and stored them away. Tomorrow I'll see if I can dig them out and get part numbers to pass on.

Good Shooting

Lindy

varmintpopper:
Searched today for Hycar washers that I had stored away, Yep, found the washers , but the part numbers and info about them was on a piece of paper that was totally Yellowed out and un-readable.
Next stop, Home Depot. I just might re-find the washers there.

Good Shooting

Lindy

fc60:
Greetings Lindy,

Been watching this post.

When is your next trip to Home Depot?

Cheers,

Dave

Navigation

[0] Message Index

[#] Next page