Messages

31

Stars Want to Sell/Want to Buy / WTB: Hoag "OO" powder Bar

« on: May 13, 2012, 08:53:54 am »

Does anyone have a "HOAG OO" adjustable powder bar that they would part with? Does anyone know if they were made in the "O" size either?

Thanks,
Grant

32

Star Reloaders / Re: Hulme Bullit Feeder

« on: May 09, 2012, 05:35:58 pm »

 :(No one on the forum has pictures of a Hulme Bullet feeder mounted on a press??   Anyone?


Grant

33

Star Reloaders / Re: Hulme Bullit Feeder

« on: May 05, 2012, 10:13:14 am »

Doc,

Thanks for the great pictures, I have a chance to pick one up for a 38, but not sure if it is complete.

Does any one have pictures of one on a press? Any product information?


Thanks,
Grant

34

Star Reloaders / Hulme Bullit Feeder

« on: May 03, 2012, 04:16:33 pm »

Anyone have any information on the Hulme Bullet feeders? I understand they are not commonly found. Does anyone have pictures of one on a press? Any help would be appreciated.

Grant

35

Star Reloaders / Hulme Case feed

« on: April 26, 2012, 10:22:13 pm »

Does anyone have any experience with a case feed like this? Is the hole on the side at the bottom how it is attached to the press?


Thanks

36

Star Reloaders / Re: Star crank shaft assembly

« on: September 12, 2011, 02:51:40 pm »

Bruce,

The sizer that I have does not fall with the weight of the handle. The two guige rods are clean and lubed. I did find that if I heated the shaft with a hair drier that it would fall, so my guess is that the shaft needs to be cleaned. Thoughts? am I procceeding the correct way?

Grant

37

Star Reloaders / Star crank shaft assembly

« on: September 12, 2011, 01:18:38 pm »

How does the crank shaft assembly#116 get removed from the star sizer? I have removed the bolt and washer from the end plate and removed the handle. Any help would be appreciated.

Grant

38

Star Lubricator & Resizers / Size die install

« on: September 09, 2011, 04:13:53 pm »

Just picked up a Star Sizer, First of many questions.
How difficult shoiuld it be to install the die into the press? Both the die and press are clean just a little oil on the die.

Thanks,
Grant

39

Star Reloaders / Brewster indexer.

« on: May 02, 2011, 06:06:16 pm »

Does anyone have any experience with a Brewster Indexer?